Saturday 3 March 2012

Creating a new oak casing for the new power unit

Testing animatronic head with wooden mains plugThe head finally has a working wooden power plug.  The first power unit was burned out by soldering a new lead on before it even got the oak round it!

The second stopped working after it was encased in oak. It was not obviously damaged externally. It is likely it was broken inside by vibrations from the sander, as the plug was in situ, when it was subjected to some serious RPM.






See below for the steps undertaken to create this...

Routing out void to fit plug into wooden casing
A new casing in the vice, being routed out to fit the plug.

Note the guide rail cramped to the bench. This is a guide for the handheld router to keep to a reasonably straight edge






Routing out void to fit plug into wooden casing
A close-up of the inside of the casing, partly routed.









Fitting wooden casing for mains plug
Fitting the plug to test the depth









Wooden casing for mains plug separated
The casing with routing completed, prior to finishing.









Wooden casing for mains plug
Checking the plug fits with both halves of the casing in place.

As the last unit was killed by vibrations, this one was to be finished without the unit in it though






Sawing off screw head to make guide pin
To do this, the two halves of the casing needed to be sanded whilst kept aligned. The plug had done this in the previous attempt, but was not in place in this version.

Tow screws were inserted in one half of the casing to create guide pins to keep the halves aligned whilst sanding.







Wooden casing with guide pin in place
The guide pin after the screw head has been removed. This is to fit into a hole in the other half of the casing. (there are two of these)












Wooden casing showing guide pins
To mark the other half of the casing, the two halves were aligned, then pressure applied in the vice.











Detail of wooden casing showing guide pin impression

This created an indentation, to mark where the alignment hole needed to be drilled.











Wooden casing for mains plug, showing guide pins
The completed halves.









Wooden casing for mains plug, before finishing
The completed casing, ready to be finished












Orbital sander
The orbital sander responsible for destroying the last unit with vibrations.










Wooden casing for mains plug after finishing (cracked)
The finished casing after planing and sanding. Unfortunately it cracked when the router bit in a bit too strongly. This cracked was later glued back together






No comments:

Post a Comment